Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MTU issue

hi, i have DSL connection from my service provider, he sets mtu 1492 on its dsl modem, My LAN has cisco 2960 switches which is by default 1500 mtu size. The problem is when i connect dsl modem to my LAN switches it stops browsing and when i connect it directly to system it start browsing. what might be the issue and how to resolve it.

Thanks

7 REPLIES
Cisco Employee

Re: MTU issue

Hi,

When the modem is connected to the switch, is it acting as a DHCP server ?

How are configured your hosts: static IP or DHCP client ?

The 1492 MTU configured on the DSL interface is normal as you have 8Bytes of overhead due to PPPoE encapsulation.

HTH

Laurent.

Blue

Re: MTU issue

Hi:

"The problem is when i connect dsl modem to my LAN switches it stops browsing and when i connect it directly to system it start browsing."

This sentence makes no sense. Can you clarify.

In short, your MTU should be the same as your providers, if not even a bit smaller to prevent fragmentation.

HTH

Victor

Hall of Fame Super Gold

Re: MTU issue

Do you have a cisco router in network ?

If yes, something can be done about that.

If not, you need to seek solution from dsl modem vendor.

New Member

Re: MTU issue

hi,

1. you might want to check your switch configuration? (i.e. vlan configure?)

2. what is the mtu size on your pc?

New Member

Re: MTU issue

I used to see this a lot a few years ago when I used DSL. The problem is that the dls modem is looking for your PC's MAC address. With linksys, dlink, etc.. to resolve this you would clone your pc's MAC address to the router.

New Member

Re: MTU issue

You need to define the problem better.

MTU path discovery maybe broken if the DSL router is stopping ICMP packets.

Your PC sends a packet with size 1500, the DSL router should drop the packet and send an ICMP packet back to your PC to get the PC to reduce the packet size to 1492, is this working?

New Member

Re: MTU issue

hi,

Thanks all of you for your reply, actually i figure out the problem, My vlans and the DSL Lan ips are with the same network. i.e my vlan management ips are with network 192.168.1.0/24 and my DSL LAN ip is also 192.168.1.1/24.

All of my vlans are assigned ip range 192.168.1.2-10 but my DSL LAN is 192.168.1.1 don't know why it is causing problem. Any suggestion

313
Views
0
Helpful
7
Replies