Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MTU site to site on Router 1800

Hi

It seems that standard MTU value is set to 1399 when configured router over web SCM.

Get problem on my windows AD and need to increase this to 1492 over the VPN tunnel.

How can I do that? is it on tunnel or card interface inside/outside

Kind please HELP ;)

3 REPLIES
Hall of Fame Super Gold

Re: MTU site to site on Router 1800

Which kind of tunnel is that exactly?

if you want to find the MTU by yourself, proceed as following:

- remove all metu and ip mtu statements from involved interfaces.

- do "ping x.y.z.k df size to the other end of tunnel, progressively inreasing or decreasing size untile the largest possible is found.

- Configure this value as "ip mtu" on the tunnel interface.

New Member

Re: MTU site to site on Router 1800

I configured my routers with SDM tool and like the help function says that default value is 1400.

MTU

Enter the largest amount of data, in bytes, that should be allowed in a packet travelling through the tunnel.

SDM Default: 1400

How should I change that to 1492 or 1500 by telenet?

Hall of Fame Super Gold

Re: MTU site to site on Router 1800

Conf term

interface XXX

mtu YYY

or, for a tunnel interface

interface tunnel X

ip mtu Y

exit, wr mem

Hope this helps, please rate post if it does!

200
Views
0
Helpful
3
Replies
CreatePlease to create content