I have a Cisco 3620 configured for ADSL access with an external DSL modem in bridge mode. I have attached the relelevant working configuration below. This is working for me for quite some time. I am interested to use MLPPP with the same router and one modem to begin with. I have already the MLPPP login from the ISP and I am trying to setup single link PPP for now. I have read through the documentation on PPP but I could not find a configuration guide for this scenario. I am hoping someone may have some input on how I should approach this. Thanks in advance, flmetel2010.
CURRENT WORKING CONFIG ==================== vpdn enable vpdn session-limit 1 ! vpdn-group 1 request-dialin protocol pppoe
interface Ethernet0/0 description TO ADSL MODEM (BRIDGE MODE) no ip address half-duplex pppoe enable pppoe-client dial-pool-number 1 no cdp enable ! interface Ethernet0/1 description INTERNAL LAN ip address x.y.z.t a.b.c.d ip nat inside
interface Ethernet0/2 no ip address shutdown ! interface Ethernet0/3 no ip address shutdown
interface Dialer1 ip address negotiated ip nat outside encapsulation ppp dialer pool 1 dialer-group 1 no peer default ip address keepalive 3 ppp authentication pap callin ppp pap sent-username xxxxxxxxxxx password 7 000000000000000000 =====================================================
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.