Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multicast between DMZ to DMZ, DR to HQ site

If I wanted to configure two servers in DMZ's in two seperate locations to allow multicasting end to end, is this possible?

Can I enable multicasting on a single switch port to another port end to end?

Do all routers between the two servers have to allow multicasting as well?

1 REPLY
Silver

Re: Multicast between DMZ to DMZ, DR to HQ site

One way You can achieve this by MVPN , Second way you can achieve by Milticast over GRE {So i can do routing properly, Even IPSEC enable on firewall.}

See document of

http://www.cisco.com/en/US/tech/tk828/technologies_configuration_example09186a00801a5aa2.shtml

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00807b90ce.html

Regards,

Dharmesh

124
Views
0
Helpful
1
Replies
CreatePlease to create content