Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

multicast boundary

Hi community,

Does the ip multicast boundary command work in both directions i.e in and out?

Thanks,

Mats

  • WAN Routing and Switching
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: multicast boundary

Yeah, it works in both directions. Check

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a00800ca76d.html#wp1058494

Usage Guidelines

Use this command to configure an administratively scoped boundary on an interface to filter multicast group addresses in the range defined by the access-list argument. A standard access list defines the range of addresses affected. When this command is configured, no multicast data packets are allowed to flow across the boundary from either direction.

2 REPLIES
Silver

Re: multicast boundary

Yeah, it works in both directions. Check

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a00800ca76d.html#wp1058494

Usage Guidelines

Use this command to configure an administratively scoped boundary on an interface to filter multicast group addresses in the range defined by the access-list argument. A standard access list defines the range of addresses affected. When this command is configured, no multicast data packets are allowed to flow across the boundary from either direction.

New Member

Re: multicast boundary

Thanks for the clarification.

432
Views
0
Helpful
2
Replies
This widget could not be displayed.