I need to test the performance of my newly deploy ASA 5510 IPSec Tunnel network using the multicast traffic. Anyone body suggest me how to do generate the huge multicast traffic in order toe see the traffic / performance of the tunnel ?
Just pure ipsec tunnel does not support multicast traffic.
You would need to configure GRE over IPSec tunnel to pass through multicast traffic, and GRE tunnel is not supported on ASA, hence, the GRE needs to be configured on router behind the ASA, and ipsec can either be terminated on the router or the ASA.
Thx for your reply. I believe unicast traffic able to pass though the IPSec Tunnel . Am I right to say that? And is there anyway to generate a lot of unicast / multicast traffic from one end to another end?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...