Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

multicast igmpv2/3 with apple quicktime

Hi 2 all,

we have several 2821 routers, which have multicast (pim sparse) mode enabled.

We are using igmp version 2 on the routers client interfaces, where the receiver is connected to.

we have two problems:

first:

=======

the problem is, that the client has apple quicktime installt as the viewer.#

it seems that quicktime only send igmp v3 to the routers interface, which is configured for igmp v2.

we have to use igmp v2 for other reasons.

so the question:

does anybody know how to configure quicktime to use only igmp v2 ???

second:

=======

when we start quicktime at the receivers side, the router "thinks" that this software is a sender too!!

but we only want to receive.

thanks for any answer and greetings from austria!

  • WAN Routing and Switching
262
Views
0
Helpful
0
Replies
This widget could not be displayed.