Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Multicast issue

hi all;

i'm wondering a strange issue with multicast, i explain: i have configured two Cisco 1841 CE for multicast to do a membership with the multicast group 224.1.1.1, i joined the group but when i initiate a multicast traffic from a PC (Source), i don't receive it from the PC (destination), my configuration and traces are attached to

best regards;

Med

3 REPLIES
New Member

Re: Multicast issue

Hi all;


please note that the PE routers are from Juniper,

any help will be appreciated

Med

New Member

Re: Multicast issue

anyone has an idea

i'm waiting your feedback

best regards

Med

Hall of Fame Super Bronze

Re: Multicast issue

Clear mroute table on both routers with the command 'clear ip mroute'.

At the receiver, initiate the join to the group and from the sender activate the application for group 224.1.1.1

Once you do that, please post the 'show ip mroute' from both routers along with 'show ip pim neighbor' and 'show ip pim rp-mapping'.

Also, what type of application are you using for the mcast test?

Regards

Edison

344
Views
0
Helpful
3
Replies
CreatePlease to create content