Could you please draw the diagram of device (including multicast source, destination, RP, MA) interconnection. Please add to the diagrams all the IP-addresses we could see over "sh ip mroute" and "sh ip pim rp map".
Sorry, I didn't understand the problem. What is not working?
You wrote: "... however we can not Multicast to the switches that the servers are sitting on", but I thought server is supposed to be a multicast source... not the destination!
Servers are sitting on Switch A and Switch B on ports fa0/15; we need to send the multicast to both servers using 22.214.171.124 but only Switch A will receive the multicast. My biggest concern is why the Uptime is not incrementing on the sh ip igmp groups, the servers that are working on both Switches A and B the Uptime is incrementing, which is on another router example:
Group Address Interface Uptime Expires Last Reporter Group Accounted
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...