Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multicast mtrace question

Is there a way to get the name of the router i.e. the router prompt with the interface address in the output of the mtrace command instead of just the interface addresses.

R1#mtrace 1.1.1.1 2.2.2.2 239.1.1.1.

Type escape sequence to abort.

Mtrace from 1.1.1.1 to 2.2.2.2 via group 239.1.1.1

From source (?) to destination (?)

Querying full reverse path... * switching to hop-by-hop:

0 1.1.1.1

-1 * 1.1.17.1 PIM [1.1.1.1/32]

-2 * 1.12.1.13 PIM [1.1.1.1/32]

  • WAN Routing and Switching
1 REPLY
Silver

Re: Multicast mtrace question

Did you try Mstat Command

mstat {source-name | source-address} [destination-name | destination-address] [group-name | group-address]

2) Once you do MTRACE after use PING and resolve it. If you would perticular hop name.

Regards,

Dharmesh Puorhit

261
Views
0
Helpful
1
Replies
This widget could not be displayed.