Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

multicast problem

Hi,

We encountered one problem with multicast behavior after software upgrade on our Cat3750.

Our used network topology is shown below:

H_1

H_2

|

|

R1--------RP

|

|

R2--------H_3

H_1 ? is multicast Receiver;

H_2 ? is multicast Receiver;

H_3 ? is multicast Sender and Receiver;

R1 ? is Cisco7606;

R2 ? is Cat_3750 with IOS  c3750-advipservicesk9-mz.122-35.SE1;

RP ? is another router which perform Rendezvous point function;

Problem description:

H_3 is multicast sender and receiver which sending and requesting the same multicast group.

Then if receiver H_1 or H_2 request this multicast group they will have to wait certain period of time (more then 2min) while they will get this traffic.

They will receive multicast traffic only when R flag in (S, G) entry on router R1 will change from R to T.

If one of the receivers (H_1) is already receiving multicast traffic for this group and other receiver H_2 will request this group again it will receive multicast traffic immediately without any delay.

We encountered this problem also with IOS versions:

12.2(25) SEC2

12.2(25)SEE2

12.2(25) FZ

There is no this problem with 12.2(25)SEC1 (but this version has security holes and we don?t want to use it).

Is it possible to know in which IOS release it will be or it is fixed?

Thanks

3 REPLIES
New Member

Re: multicast problem

Just curious:

how are you mapping the RP?

New Member

Re: multicast problem

Also, can you post the relevant multicast config for the 3 routers?

New Member

Re: multicast problem

We are using pim-sparse mode on all our routers and static mapping for RP.

139
Views
0
Helpful
3
Replies
CreatePlease to create content