Multiflex Trunk config for data T1

[jneiberger]

I'm having trouble with a multiflex trunk configuration. This is the first multiflex trunk module I've ever tried to configure and my circuit doesn't seem to be working, yet it doesn't seem to be a problem with my carrier.

Here is my config:

controller T1 0/0/0

framing esf

linecoding b8zs

clock source line

channel-group 0 timeslots 24 speed 64

interface serial 0/0/0

ip address 10.x.y.z 255.255.255.0

Is that the correct config for a plain old full T1 for data? I can't seem to find an example of that in the documentation.

Thanks!

John

[jneiberger]

Nevermind, I'm a dork. It should be "timeslots 1-24".

:-)

I was accidentally attempting to configure a 64K fractional DS1 on channel 24. heh heh.... That's not quite what I wanted.

Thanks,

John

[chrisserafin]

Here is my MFT card config with a PRI

It might help...?

network-clock-participate wic 0

ip subnet-zero

!

isdn switch-type primary-ni

controller T1 0/0/0

framing esf

linecode b8zs

channel-group 0 timeslots 1-24

interface Serial0/0/0:0

description MCI MPLS Circuit

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

ip nbar protocol-discovery

encapsulation frame-relay

ip route-cache flow

frame-relay lmi-type cisco

max-reserved-bandwidth 90

service-policy output xxxxxxxxxxxxx1.0

!

interface Serial0/0/0:0.1 point-to-point

description MCI MPLS Circuit xxxxxxxxxxxxxxx

bandwidth 1536

ip address 1xx.220.198.134 255.255.255.252

ip pim dense-mode

frame-relay interface-dlci 100 IETF

!

cisco80211

Chris Serafin

IT Security / Cisco VoIP Engineer

chris@chrisserafin.com