I have two different ISP's and two routers that are configured with eBGP between the ISP's and iBGP between the two routers. I am getting full routes plus a default route. I have 2 network addresses ISP A 10.117.125.0 /24 and ISP B 10.51.170.0 /24. (I have changed the ip addresses for this example. ) I would like it if ISP A fails then ISP B will route that subnet. This happened the other day and it did not work. The ISP is setup correctly and i see that i am missing a network statement, but is there anything else in this config that is wrong?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...