Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multilink config

Hi

I need a help ASAP on the below setup.... please

Can i configure multilink on 2811 router with two internet links(2MB and 1MB) both termniated on 2811 router?

Regards

Venkat.

Everyone's tags (1)
2 REPLIES
Silver

Re: Multilink config

You can multilink ckts coming from the same isp, but that is a question for your isp.  Some providers do not allow this.  I worked with Telmex on a 4x T solution and had to run BGP for load sharing because they did not allow me to run multilink.

New Member

Re: Multilink config

Yes you can, providing you configure both ends for PPP multilink:

http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_media-ind_multi_ppp_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1054168

Basically create a multilink interface:

interface multilink 1

ip address x.x.x.x

ppp multilink

ppp multilink multiclass

And assign to your serial interfaces:

interface serial 0/0

encapsulation ppp

ppp multilink group 1


interface serial 0/1

encapsulation ppp

ppp multilink  group 1

691
Views
0
Helpful
2
Replies