Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multilink Configuration

I have a customer that has (2) T1 PPP circuits coming into his location. He wants to join them together but they don't both belong to the same provider. Will a Multilink interface work in this scenario?

3 REPLIES
Blue

Re: Multilink Configuration

No, multilink must be configured on both ends. The best you can is to load balance between the separate links.

Please rate helpful posts.

Hall of Fame Super Silver

Re: Multilink Configuration

Brian

There was a discussion about a simmilar question a while ago on the forum. I believe that as long as the 2 PPP circuits begin on the same router and terminate on the same router that multilink should work. Someone else made the point that if the circuits were from different providers that there might be differences in delay and that might cause problems for multilink.

While I agree that it is much better if the circuits are from the same provider, I believe that multilink can work over different providers. If anyone in the forum has actually done this and can tell from experience what happened, I would be delighted to know it.

[edit: David makes a good point: I had assumed that the 2 PPP circuits began and ended on the same routers and were provided by different providers. David assumes that the 2 circuits terminate in different routers. If the circuits do not terminate together, then David is quite right that multilink will not work. Perhaps you can clarify what the situation is.]

HTH

Rick

New Member

Re: Multilink Configuration

David is correct the far end routers belong to the carriers so in this scenario then multilink will not work. Thanks for the quick response to both of you!

238
Views
4
Helpful
3
Replies