Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multilink configuration

Is there any way to configure a multilink bundle with one ethernet drop link and one serial link. If so guide me with configuration steps please

4 REPLIES
New Member

Re: Multilink configuration

hi your scenario is not clear can u provide more details.

Regards

Binoy

Bronze

Re: Multilink configuration

Ethernet is not a point to point link so it does not support PPP encapsulation to participate in multilink. The only exception is PPPoE but that has some other requirements not just PPP.

I don't think you can bond these links with MLP.

Daniel

Re: Multilink configuration

You cannot do PPP multilink on an ethernet interface as ethernet is a multiaccess network.

HTH, rate if it does

Narayan

New Member

Re: Multilink configuration

Hi,

A multilink association between a ethernet interface and a serial interface seens to be impossible.

But you can do a kind of multilink association over ethernet interfaces. This kind of "feature" is called EtherChannel. With it you can group ethernet interfaces in a load balance scheme.

See more informations in http://www.cisco.com/warp/public/473/4.html

307
Views
0
Helpful
4
Replies