Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

multilink connection

Dear friends,

I have a pair of MWR-1941-DC router which has built in Y cable configuration. It has two E1. Now I want to multilink these two E1 so that they act as a single. So will you provide methe multilink configuration?

Bikash

1 REPLY

Re: multilink connection

Create a multilink interface

interface multilink 1

ip address x.x.x.x y.y.y.y

ppp multilink

ppp multilink group 1

Assign the individual serial interfaces to the multilink group

Controller e1 1/0

channel-group 0 timeslots 1-31

controller e1 1/1

channel-group 0 timeslots 1-31

interface serial 1/0:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

interface serial 1/1:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

http://www.cisco.com/en/US/products/hw/routers/ps4062/products_configuration_guide_chapter09186a008076fdce.html#wp1055832

HTH, rate if it does

Narayan

163
Views
4
Helpful
1
Replies
CreatePlease login to create content