Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Multilink Full and Fractional T1?

Is it advisable to multilink a full T1 and fractional (1/2) T1? Are there any issues with this configuration we should be aware of? Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Multilink Full and Fractional T1?

Hi Friend,

I had raised a similar query with TAC. You can definitely run multilink over different bandwidth links..

Have a look at the last TAC comment on the following post

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddc720b

HTH

Narayan

3 REPLIES

Re: Multilink Full and Fractional T1?

Hi Lori

AFAIK its better to use multilink bundle with the links which has same characteristics.

You can get better results if you bundle 2 links with same bandwidth available..

regds

Re: Multilink Full and Fractional T1?

Hi Friend,

I had raised a similar query with TAC. You can definitely run multilink over different bandwidth links..

Have a look at the last TAC comment on the following post

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddc720b

HTH

Narayan

Community Member

Re: Multilink Full and Fractional T1?

Thank you both.

The comments from TAC are exactly what I was looking for.

152
Views
0
Helpful
3
Replies
CreatePlease to create content