Configuration of CEF (or removing CEF) or changing its loadsharing method will not affect the way that multilink distributes traffic. Multilink manages its own usage of the links and should spread the packet data across all available links in the bundle all four at once.
If you think that you have a bad T1 you might remove it from the multilink bundle and see if performance changes. This would also make the T1 available for testing purposes.
rick, somewhere i read that in multilink Data Packet is fragmented as per the number of link participating in the Mulitlink group. for exam ple if you are bundle the 4 T1 link then it will fragment the single packet in to 4 small fragment of same size and then send the each fragment on each link.
Multilink sharing there own to distribute data, so no relation with CEF, if you have 4 E1 in multilink configuration and any of the link will having high error, there one command to put thresold limit.
I do not believe that there are any other load sharing features that you can configure on multilink. The multilink is treated as a single entity for routing purposes and has a single IP address which is used for any traffic going over any of the links within the bundle. The routing process gives IP packets to the multilink to forward and you have no control after that.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.