Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multilink on serial interface

I am a beginner infact novice in configuring multilink. Can we configure multilink by utilising the serial links terminated on multiple/different routers?

2 REPLIES

Re: Multilink on serial interface

HI Veena, [Pls RATE if HELPS]

Here is the sample configuration:

--------------------------------------

interface Multilink1

description *****MULTILINK in Mumbai*****

ip address x.x.x.x

ppp multilink

ppp multilink group 1

!

!

interface Serial0/3/0

description **CIR 1**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Serial0/3/1

description **CIR 2**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Multilink1

description *****MULTILINK in Chennai*****

ip address x.x.x.x

ppp multilink

ppp multilink group 1

!

!

interface Serial0/3/0

description **CIR 1**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Serial0/3/1

description **CIR 2**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

PLS RATE if HELPS.

Best Regards,

Guru Prasad R

Re: Multilink on serial interface

Hi veena,

The 1st of concept of creating multilink is that the physical interfaces to be bundled in to multilink has to terminate on a single router at both ends.

hope that clarifies.

pls rate all helpful posts.

162
Views
0
Helpful
2
Replies