Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Multilink over Frame Relay

Hi All,  

I am trying to configure MLoFR and want to bundle two serial links as multilink. Please refer the configuartion at my end router terminating both P2P serial connectivity with ISP.


interface Serial0/0/0
no ip address
no ip redirects
no ip unreachables
encapsulation frame-relay IETF
frame-relay lmi-type ansi
end

interface Serial0/0/0.16 point-to-point
frame-relay interface-dlci 100 ppp Virtual-Template5
 

interface Serial0/0/1

no ip address
no ip redirects
no ip unreachables
encapsulation frame-relay IETF
frame-relay lmi-type ansi

interface Serial0/0/1.16 point-to-point
frame-relay interface-dlci 100 ppp Virtual-Template5

interface Virtual-Template5
no ip address
ppp multilink
ppp multilink group 1

interface Multilink1
ip address x.x.x.x 255.255.255.252
no ip redirects
ppp multilink
keepalive 1
ppp multilink interleave
ppp multilink group 1
ppp multilink fragment delay 1000

    

Observations: 1- Both PVC's on FRame relay is coming up.

2) Both serial interfaces and subinterfaces are up & working.

3) Interface virtual template is not coming up and showing interface and line protocol down        .

4) Multilink is also down & showing inactive.

show ppp multilink
No active bundles

Multilink1 (inactive)
  Member links: 3
    Vi2 (inactive)
    Vi3 (inactive)
    Vt5 (inactive)

Multilink1 is down, line protocol is down

  Hardware is multilink group interface

  Internet address is

  MTU 1500 bytes, BW 3088 Kbit/sec, DLY 100000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation PPP, LCP Closed, loopback not set Multilink1 is down, line protocol is down
  Hardware is multilink group interface
  Internet address is 172.30.8.209/30
  MTU 1500 bytes, BW 3088 Kbit/sec, DLY 100000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation PPP, LCP Closed, loopback not set

Please clarify :

1) Do i need to inform and confirm ISP to also create the similar multilink configuration in ISP end device.

2) Does any additional configuration i require to make the multilink active and working.

Please help with the clarifications and suggestions.

Regards

Manish

1 REPLY
Hall of Fame Super Gold

Multilink over Frame Relay

1. Yes. Unlike ISP will configure multilink (and is unlikely that that they will), that will not work.

2: See 1.

146
Views
0
Helpful
1
Replies
CreatePlease to create content