cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1165
Views
0
Helpful
1
Replies

Multilink PPP between HSSI and HWIC-2T

tranarison
Level 1
Level 1

Dear all,

µWe have 2 routers. One of the router has 2 HSSI interfaces and the other has 2  HWIC-2T.
Each HSSI is connected to one port of each HWIC-2T  interface.

We used to configure MLPP between same models WIC.

Using the same best practice configuration, we are not able to bring interfaces to UP status.

I'd like to know if it is possible to configure multilink  between Those cards (HSSI and HWIC-2T).

Regards.

1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Tranarison,

HSSI is a totally different standard using ECL and negative voltages you cannot connect it to a synchronous serial.

>> One of the router has 2 HSSI interfaces and the other has 2  HWIC-2T.
Each HSSI is connected to one port of each HWIC-2T  interface.

the problem is not multilink PPP but different physical layer standards

see

http://www.cisco.com/en/US/products/hw/routers/ps341/products_tech_note09186a00801c8c42.shtml#comparison

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco