Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multilink PPP between HSSI and HWIC-2T

Dear all,

µWe have 2 routers. One of the router has 2 HSSI interfaces and the other has 2  HWIC-2T.
Each HSSI is connected to one port of each HWIC-2T  interface.

We used to configure MLPP between same models WIC.

Using the same best practice configuration, we are not able to bring interfaces to UP status.

I'd like to know if it is possible to configure multilink  between Those cards (HSSI and HWIC-2T).

Regards.

Everyone's tags (2)
1 REPLY
Hall of Fame Super Silver

Re: Multilink PPP between HSSI and HWIC-2T

Hello Tranarison,

HSSI is a totally different standard using ECL and negative voltages you cannot connect it to a synchronous serial.

>> One of the router has 2 HSSI interfaces and the other has 2  HWIC-2T.
Each HSSI is connected to one port of each HWIC-2T  interface.

the problem is not multilink PPP but different physical layer standards

see

http://www.cisco.com/en/US/products/hw/routers/ps341/products_tech_note09186a00801c8c42.shtml#comparison

Hope to help

Giuseppe

907
Views
0
Helpful
1
Replies
CreatePlease to create content