Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multilink PPP

Hi, I have 2 T1 circuits from the ISP and I need to bundle them can anyone assist me with the config? Where would I place the IP address on the physical or logical interface?

2 REPLIES

Re: Multilink PPP

You generally place it on the logical interface:

int mul1

ip address x.x.x.x

ppp multilink group 1

int s0/0/0

no ip address

encapsulation ppp

ppp multilink

ppp multilink group 1

int s0/0/1

no ip address

encapsulation ppp

ppp multilink

ppp multilink group 1

If one of your circuits go down, you won't lose any traffic.

HTH,

John

HTH, John *** Please rate all useful posts ***
New Member

Re: Multilink PPP

In the documentation it says that I need to create a policy map. Do I really need to do that? Also there will be VOIP going over the line would I have to add anything to this config for the VOIP ? Thanks for your help!!!!!

105
Views
0
Helpful
2
Replies