Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multilink problem

Sir,

I have bundled 2 E1s as multilink.One side cisco 7609 router.Other side cisco 2611 router.Multilink is working properly if both E1s are up and having no loss.But if one E1 is having error (i.e serial is up and line protocol is up but reliabiltiy is very less about 200/255)then both links are having problem.Error one E1 affects other E1 also since it is multilink.Is there any command to detach errored E1 automatically.Kindly give me a solution

Thanks and Regards,

Senthil

191
Views
0
Helpful
0
Replies