Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multilink without L3 IP address

Can i configure Multilink witout ip address as a L2 Connectivity.

regards,

2 REPLIES

Re: Multilink without L3 IP address

Moorthy,

Yes its possible. You will still have to bridge traffic between your lan interface and multilink interface to pass traffic.

int mu 1

no ip add

bridge-group 1

encap ppp

int e0

no ip add

bridge-group 1

bridge 1 protocol ieee

no ip routing

int s0/1

no ip add

encap ppp

ppp multilink

multilink-group 1

int s0/2

no ip add

encap ppp

ppp multilink

multilink-group 1

Hope that helps!

PS: Please rate the post if it helped you!

New Member

Re: Multilink without L3 IP address

I need to setup on 7609 router Over EOMPLS.can u please suugest accordingly.

Regards,

Moorthy.

91
Views
2
Helpful
2
Replies