first of all the requirements you want is possible, but by comparing your current network diagram and the requirements you looking to achieve i think its a bit complicated, because according to your requirements you need a policy based routing with IP SLA to get the traffic routed based on traffic source
but the problem is you have the firewall is sitting in the central point between your edge routers and firewalls can not do PBR
it can be resolved using couple of ways such as multiple context in the firewall and so on .. but you need to keep it as simple as possible
i think one of the simple ways is to have a third router to be placed infront of the firewall and the routers will connect to this router in this case you will configure this new router as the PBR router to send the traffic based on source to the desired ISP/router
bellow is a configuration example that help you to understand and configure the third router suggested above
by the way if you think that adding a third router infront of the firewall will make single point of frailer, i think you already have this issue by having one firewall
As u suggested i can not get one more router in between to configure PBR. one of the edge router is a cisco integrated router 2801 which will support PBR config I guess.....could you please confirm whether it support to configure PBR on the integrated 2801 router.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...