I am stuck in problem when doing a senerio and need your help. I create one topology in this, My Router CE_router is customer router, which is connected to BSNL_ISP_1, the BSNL_ISP_1 node going in MPLS cloud. In my senerio i have create datacenter which is connected to other side of MPLS network and users are able to access servers with My primary network. Now i am going t add one more ISP, in case of failover my primary network.
1. If my primary network goes down then network automatically switch and going out from Failover network (VSAT). In this case My lan network is remain same.
2. One time only one network is usable and that is my primary network in case of failover switch to other ISP and when my primary link comes up it again switch on that.
3. when both link is up then always go route from my primary network and secondary network become inactive.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...