Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple Links P-2-P

Hi

I would shortly have Three sites connected with each other
Site_A connected to Site_B
Site_A connected to Site_C
Site_B connected to Site_C

All are connected via Wimax with Ethernet Interface 10/100 ( 6MB for each connection )

Is following OSPF config Ok in terms of redundancy and loop free
If one of the link goes down still there shoud be full reachability

Site_A connected to Site_B
Site_A : 192.168.1.1/30
Site_B : 192.168.1.2/30

Site_A connected to Site_C
Site_A : 192.168.1.4/30
Site_C : 192.168.1.5/30

Site_B connected to Site_C
Site_B : 192.168.1.7/30
Site_C : 192.168.1.8/30


SITE_A
router ospf 1
network 192.168.1.1 0.0.0.0  area 0
network 192.168.1.4 0.0.0.0  area 0
network 10.10.10.0 0.0.0.255 area 0


SITE_B
router ospf 1
network 192.168.1.2 0.0.0.0  area 0
network 192.168.1.7 0.0.0.0  area 0
network 10.10.20.0 0.0.0.255 area 0


SITE_C
router ospf 1
network 192.168.1.5 0.0.0.0  area 0
network 192.168.1.8 0.0.0.0  area 0
network 10.10.30.0 0.0.0.255 area 0

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Multiple Links P-2-P

Hello Saquib,

configuration is fine but IP addressing should be reviewed:

when using /30 subnets, each uses 4 addresses

192.168.1.0/30 - 192.168.1.0 base address, 192.168.1-2 usable addresses; 192.168.1.3 broadcast

192.168.1.4/30   192.168.1.4 base address, 192.168.5-6 usable addresses; 192.168.1.7 broadcast

192.168.1.8/30   192.168.1.8 base address, 192.168.9-10 usable addresses; 192.168.1.11 broadcast

hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: Multiple Links P-2-P

Hello Saquib,

configuration is fine but IP addressing should be reviewed:

when using /30 subnets, each uses 4 addresses

192.168.1.0/30 - 192.168.1.0 base address, 192.168.1-2 usable addresses; 192.168.1.3 broadcast

192.168.1.4/30   192.168.1.4 base address, 192.168.5-6 usable addresses; 192.168.1.7 broadcast

192.168.1.8/30   192.168.1.8 base address, 192.168.9-10 usable addresses; 192.168.1.11 broadcast

hope to help

Giuseppe

New Member

Re: Multiple Links P-2-P

Oh Yes.

Thanks.

Any more clue on my EIGRP post.

208
Views
0
Helpful
2
Replies
CreatePlease to create content