Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multiple path aggregation

I am trying to find a way to aggregate 2 serial links that are being connected though an ATM cloud. So that the networks on both sides see them as one link.

(see attached)

3 REPLIES
Purple

Re: Multiple path aggregation

Unfortunately, I could not open your drawing since I have an older version of Visio.

However, based on your requirements, there is one possible solution that you can use - Multilink PPP over ATM. That would result in the creation of a multilink interface which you can then treat as a single logical link.

Here's a link to more info on it:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hqos_c/part30/ch05/qslfiatm.htm

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Multiple path aggregation

changed attachement format..

Not sure PPP multilink will work across 2 routers..

Purple

Re: Multiple path aggregation

Hi Jim,

I think I see what you are getting at... probably the best option for you is to configure a first-hop redundancy protocol like HSRP or better still, GLBP so that you don't have to go around changing the default gateway on your hosts when one of the links/routers fails.

Hope that helps - pls rate the post if it does.

Paresh

100
Views
0
Helpful
3
Replies