I'm trying to emulate multiple routers for testing purposes without using 7 different physical routers. I've written static routes so the traffic should hop from one interface to another before arriving at the final interface. The problem is since all of the networks are directly connected to my router, it allways takes the direct route. I realize this is counter-routing philosophy. But for my testbed purposes, we need to be able to run a traceroute and see all of the hops a packet would take.
Is Policy Based Routing capable of defining routing rules on a per interface basis? I'd like a rule to effect of:
if packet received on interface X and destined for network A, go to interface Y, not directly to the interface on network A.
Re: Multiple router Emulation/ Policy Based Routing
Thanks for the examples those seem like they will solve my problem. I encountered one problem. The interfaces are on a EtherSwitch NME-16ES-1G-P module, and in conf-if mode, there is no 'ip policy command available' the IOS of the module is 12.2(25)SEE2. I thought PBR was supported since at least 12.0. Do I need a newer IOS?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.