Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

multiple wan links on 1 router 1 link fail other link will auto fail

I need to have a setup where we have 2 router 2811 with on each router 3x 2meg ccts, we need ot have a situation where if 1 of the 2meg on on router fail the others will be blocked and traffic will fail-over to redundent router, is this possible?

2 REPLIES
Silver

Re: multiple wan links on 1 router 1 link fail other link will a

Hi!

What kind of link are you going to use? Are you going to use IMA? If yes, there is a feature for IMA where you set the minimum active links to 3 so when one link fails, the entire IMA bundle will fail. I don't know if multi-link ppp has the same feature.

Regards,

Albert

Community Member

Re: multiple wan links on 1 router 1 link fail other link will a

we are using ppp links, and we have a situation where 2 link are not able to bear the traffic, and we are not able to load-balance on higher level and therefor we need to have it in this mode for the time being

thx,

mijkel

216
Views
0
Helpful
2
Replies
CreatePlease to create content