I have set up 2 Cisco MWR 2941-DC routers connected via a Cisco 3750E switch in the lab, and as I looked through the sample configuration (TDM over MPLS configuration) provided, I'm confused by the diagram given.
The diagram shows MWR_A connected to MWR_B via the GigabitEthernet 0/1 ports. But there is also a connection between the two MWRs using the E1-1/0 ports. So does the packetized traffic for SAToP and CESoPSN actually get to the other MWR via the GigabitEthernet connection, or the E1 connection?
Also, does anyone know if any form of optimization or compression is applied on the traffic, especially if multiple E1s are used?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...