I have two MWR 2941's in a lab environment awaiting deployment in a SAToP environment. They are both running the latest IOS, mwr2941-adviprank9-mz.151-1.MR3.bin. After being up for about 4 days they both stop responding to telnet attempts. I do not get a reject message - it just goes to a blank secreen with a flashing cursor. The only way to fix it is to reboot.
I read that an older IOS had a similar bug on the MWR1941 but I cannot find anything about the 2941 having issues such as this.
Yes - no changes have been made whatsoever, and this will happen every four days or so, and then I'll have someone power cycle them for me. I am not in the same city as the MWR's so I cannot console up to them to look for errors. I will see if I can get some remote hands to do this for me next time it occurs.
They do still respond to pings on all up interfaces.
I do not have SSH setup but I will do that now and see if it stops responding as well.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...