Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

named access list in "ip http access-class" coomand?

I want to have only 1 access list which allows management access to router.

but:

VOR(config)#ip http access-class ?

<1-99> Access list number

Is it possible to use named access list in "ip http access-class" coomand?

Thank you.

  • WAN Routing and Switching
2 REPLIES

Re: named access list in "ip http access-class" coomand?

Tim,

It's not possible.Standard access-list is fair enough. You are going to allow particular host/network to access this device(any ip on interfaces) via http(TCP/80). If you want to allow to access on a particular interface then you may think about other ways.

Toshi

New Member

Re: named access list in "ip http access-class" coomand?

Thank you.

147
Views
0
Helpful
2
Replies