I've setup NAT on the WAN (connected to the ISP's modem) port of my Cisco 1861 router to access the internet via 2 VLANS. Now I have a setupbox from my ISP and that needs a public ip address. It's connected on one of the eight switchports on the router.
Is there a way to give it an IP address from the modem from the ISP? Because now it's still NATed. Or do I really need a switch?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...