I have a Cisco router thats purpose is to be mobile. With that said it will go from one hotel to another and get its WAN connection from the hotels public internet via DHCP.
My problem is this, the WAN interface will not pull a DHCP address when the crypto map is enable on that port, so i must turn it off then turn crypto map back on once it has received its IP address.
Second problem, Because the router gets its WAN from the hotel and most hotels require you to access their web gui and click the "I Accept" button in order to purchase or turn on your connectivity I have NAT turned on so one of my host machines can do this as I get no connectivity with NAT and VPN enable at the same time.
Right now I must manually manage this proccess of turning on and off crypto map to get DHCP and adding and removing the NAT statements after I turn on and off the crypto map.
The question I have is this a common problem and is there a common solution for it?
Thank you in advance to any help, information, or suggestions anyone may have.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...