I have a 1800 router setup with public IP on the outside FE0 and private address on VLAN1 on the inside.
ip nat outside
ip nat inside
Let say I want to use address
184.108.40.206 plugged into one of the switch port on the back of 1800 in FE3. I don't want to NAT outside inside on this port I just want this address to route out so it appears public. Is this possible without affecting the NAT setup? Obviously I can have the whole router set as no-nat and that works, im not sure if I can get this to co-exist.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...