Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT and Routing

I want to configure a 2811 such that when internal PCs wants to access a server on the Internet at port 2823 and a certain IP range. It will use the second WAN link and NAT accordingly. How can I achieve this?

3 REPLIES
Hall of Fame Super Gold

Re: NAT and Routing

Simply use a specific route for that address or address, pointing to the link you want.

Community Member

Re: NAT and Routing

How do I perform NAT for the second WAN link? I already have NAT that goes to the primary WAN link.

Hall of Fame Super Gold

Re: NAT and Routing

under interface

ip nat outside

in global.

ip nat source inside list XXX interface X/Y overload

Please rate post if it helps!

135
Views
0
Helpful
3
Replies
CreatePlease to create content