Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT and VPN

Guys,

I have a 2801 with 2 Fastethernet ports. Each one goes to a seperate IP segment. Currently, I can VPN into router and get to both IP segments. The IP segment on 192.168.253.x does not have ip nat inside, if I do enable that, I can no longer access that segment thru VPN. The other side, 10.247.1.x does have ip nat inside and can acces thru VPN. Attched is config without the ip nat inside statement on FE0/0...what do I need to do to use same outside IP for NAT and be able to VPN into both segments.

Thanks.

1 REPLY

Re: NAT and VPN

Clark,

You'll need to deny the 192.168.253.x subnet in your acl 101.

HTH,

John

HTH, John *** Please rate all useful posts ***
96
Views
0
Helpful
1
Replies
CreatePlease to create content