08-15-2010 05:24 PM - edited 03-04-2019 09:25 AM
Hi, I am trying to NAT inside hosts to access the internet but it fails and gives this error message. Can somone please help what is going on.
(NAT*: Can't create new inside entry - forced_punt_flags: 0)
interface Dialer1
ip address X.X.X.X 255.255.255.0
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
no cdp enable
ppp authentication chap callin
ppp chap hostname XX@XX
ppp chap password 0 XX
interface Vlan2
ip address 192.168.7.1 255.255.255.0
ip nat inside
ip virtual-reassembly
08-15-2010 05:32 PM
Hello,
Can you please post all the NAT configurations here?
Regards,
NT
08-15-2010 05:35 PM
Hi, that is all the NAT configuration.
08-15-2010 05:43 PM
Hello,
If that is the case, can you please try the following:
08-15-2010 05:46 PM
Hi, Thanks I have resolved it. It does help when people don't login and remove the config you put in
08-15-2010 06:06 PM
Hello,
I am glad that the issue is fixed. Please mark the thread as answered.
Regards,
NT
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: