Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAT Fails

Hi, I am trying to NAT inside hosts to access the internet but it fails and gives this error message. Can somone please help what is going on.

(NAT*: Can't create new inside entry - forced_punt_flags: 0)

interface Dialer1
ip address X.X.X.X 255.255.255.0
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
no cdp enable
ppp authentication chap callin
ppp chap hostname XX@XX
ppp chap password 0 XX

interface Vlan2
ip address 192.168.7.1 255.255.255.0
ip nat inside
ip virtual-reassembly

5 REPLIES
Cisco Employee

Re: NAT Fails

Hello,

Can you please post all the NAT configurations here?

Regards,

NT

New Member

Re: NAT Fails

Hi, that is all the NAT configuration.

Cisco Employee

Re: NAT Fails

Hello,

If that is the case, can you please try the following:

New Member

Re: NAT Fails

Hi, Thanks I have resolved it. It does help when people don't login and remove the config you put in

Cisco Employee

Re: NAT Fails

Hello,

I am glad that the issue is fixed. Please mark the thread as answered.

Regards,

NT

298
Views
0
Helpful
5
Replies
CreatePlease to create content