Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT feature set

I have Cisco 2651XM and currently running old IOS c2600-is-mz.123-26.bin (IP PLUS) which I used the NAT protocol. I was wondering can I use IP-BASE on this router and I am not sure if this feature set has NAT protocol.

Thanks,

  • WAN Routing and Switching
1 REPLY
New Member

NAT feature set

Hello

NAT is supported on IPBase images.

The image c2600-ipbase-mz.123-26.bin supports the following NAT features:

NAT - Default Inside Server Enhancement

NAT - Stateful Fail-over of Network Address Translation (SNAT) Phase 1

NAT - Ability to use Routes Maps with Static Translations

NAT - Enhanced H.225/H.245 Forwarding Engine

NAT - Network Address Translation

NAT - Static Mapping Support with HSRP for High-Availability

NAT - Support for NetMeeting Directory (Internet Locator Service - ILS)

NAT - Support of H.323v2 Call Signaling (FastConnect)

NAT - Support of H.323v2 RAS

NAT - Translation of external IP Addresses only

NAT-Support of IP Phone to Cisco Call Manager

Regards

Sush

269
Views
0
Helpful
1
Replies