Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT in PIX

Hi,

static NAT to third party is applied on PIX. One NAT is working fine another is not working now before it was. I compared the ACL with the working one both are same. It seems the second NAT is not being active. Please advise me how can I fix this issue.

Thanks,

4 REPLIES
Community Member

Re: NAT in PIX

Could some one please help me on this?

Community Member

Re: NAT in PIX

You will need to post a partial config for anybody to give you assistance...please post your ACL for NAT and I can help.

Community Member

Re: NAT in PIX

access-list out_in line 1 permit tcp 255.255.0.0 host x.x.x.x

static (inside,outside) x.x.x.x netmask 255.255.255.255 0 0

The above is the ACL and NAT both the servers. One is working fine and another is not. The native IP is reachable from firewall.

Please let me know if you need any other information.

Thanks in Advance.

Community Member

Re: NAT in PIX

any lights on this plz

235
Views
0
Helpful
4
Replies
CreatePlease to create content