Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT issue urgent

Gents

 

we have a cisco 2800 series router which is connected to 2960 layer two switch couple of servers are connected to the layer two switch. I have notised that there is nat statement on the interface of the router which is connected to the layer two switch saying ip NAT inside and then there is couple of nat statement one to one in the router.

recently we have decided that we should remove the switch as the number of servers were reduced to three. I have bought a layer 2 switching module for the router (built-in). I have just realized that how would i now do the NAT??? i am really confused

 

is there any way (to add more to the misery the WAN connection is ISDN)

1 REPLY

Hello.Just move your old

Hello.

Just move your old configuration from L3 interface to SVI (int vlanXX).

33
Views
0
Helpful
1
Replies