NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

[winston123]

Hello all,

I need to configure NAT  (ip nat inside source static 172.x.x.x. 202.x.x.x route-map voicegateway), but can't seem to find the right command.

I find the command: sh ip nat translations, but can't find the command to configure, not in the global configuration or any other sub-level either

Do i have to enable something first, before I am able to conf NAT..

HELP!.

Thanks

[vragotha]

NAT is not supported on this platform

[winston123]

Thanks a lot Vijay

[Talha Ansari]

NAT is possible on switches that have layer 4 capability like 6500... on 3560 it is not possible.

check this

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a008011c629.shtml

[winston123]

Ah i see,

Thanks a lot for your help and info