Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

Hello all,

I need to configure NAT  (ip nat inside source static 172.x.x.x. 202.x.x.x route-map voicegateway), but can't seem to find the right command.

I find the command: sh ip nat translations, but can't find the command to configure, not in the global configuration or any other sub-level either

Do i have to enable something first, before I am able to conf NAT..

HELP!.

Thanks

4 REPLIES
Bronze

Re: NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

NAT is not supported on this platform

New Member

Re: NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

Thanks a lot Vijay

New Member

Re: NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

NAT is possible on switches that have layer 4 capability like 6500... on 3560 it is not possible.

check this

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a008011c629.shtml

New Member

Re: NAT on a WS-C3560-24TS Switch ( 12.2(25)SEE3)

Ah i see,

Thanks a lot for your help and info

1643
Views
0
Helpful
4
Replies