Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT on PIX

Hi,

we have a problem to setup our pix.

Pix is set as folows:

Users in inside network (connected to inside interface) have addresses for example 192.168.30.x,192.168.31.x

Public address on pix (outside interface) are for example 193.112.1.100, 193.112.1.99....

Now when someone want to access from outside interface (193.112.1.100 - people from internet) to inside address (192.168.30.10 - server) we have a statement: static (inside outside) 193.112.1.100 192.168.30.10 netmask 255.255.255.255 0 0 which translate this traffic. That is ok.

But now we want that people from inside network 192.168.31.x that access public adress 193.112.1.100 (so their destination address is 193.112.1.100) will be returned to address 192.168.30.10.

So what is statment or how to set up this on pix?

pix have only 2 interfaces - inside (priority 100) and outside (priority 0)

Thank you.

Lubos

2 REPLIES

Re: NAT on PIX

Lobos, if I understand correctly, your inside users are trying to connect to 192.168.30.10 which is an inside server by using its Nated Public address from outside , if this is true you are looking at DNS doctoring or hairpinning.

Hairpining

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807968d1.shtml#intro

Public NAT address 192.112.1.100

Inside Local address 192.168.30.10

same-security-traffic permit intra-interface

static (inside,inside) 192.112.1.100 192.168.30.10 netmask 255.255.255.255

global (inside) 1 interface

nat (inside) 1 0 0

Community Member

Re: NAT on PIX

try with "alias" on inside interface

cris.

116
Views
0
Helpful
2
Replies
CreatePlease to create content