Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nat outside to outside

Hi Cisco community, thanks in advance for reading this post.
 
I have a small question:
 
Service                     INTERNET 
Provider                   Access
OUTSIDE                 OUTSIDE
               \                           /
                \                         /
                 \                       /
                  \                     /
 ETH0:192.168.5.1     ETH1: PUBLIC IP
                  OUR ROUTER
                       INSIDE
                   CISCO 1941
 
I just want to know if it is possible to create a NAT rule that allows the Service Provider segment [192.166.5.0/24] to access the Internet without changing the NAT interface type [from NAT OUTSIDE to NAT INSIDE] there are some other configurations that make difficult for me to make that change, I want hosts [192.168.5.15 and 192.168.15.16] to access the Internet.
 
Any Ideas?
 
Thanks in advance
Everyone's tags (2)
2 REPLIES

Hello.Could you please

Hello.

Could you please provide your current configuration for NAT on the router and show ip nat stat/sh ip nat trans?

Silver

http://www.cisco.com/c/en/us

http://www.cisco.com/c/en/us/support/docs/ip/network-address-translation-nat/6505-nat-on-stick.html

 

you can get the clue from this article

101
Views
0
Helpful
2
Replies
CreatePlease login to create content