Actually i was suggest it's memroy issue but it's not, there is enough memory.
So in order to islate the probelm let's trun off the IP nat Translation time-out command and check how the life gone be, if this doesn't work i think we gone use some Ipsec debug commands, but let's try the NAT time-out first.
You May accept or ignore my idea, i'm just trying to isolate the problem with you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...